Hi, i'm in the environmental hydraulic laboratory. I want to use celeria to simulate some conditions about rip current. I downloaded celeria and read user manual for many times. Finally i tried to run 'celeria.exe' and selected input file properly. However, it showed me white view and after few seconds it has just shut down!! My version of DirectX is 12, and I think I've satisfied all qualification for running the program. Please someone let me know how to solve this problem ㅠ.ㅠ

Hallo everybody I set theese initial conditions as "Settings for Boundaries" in the .cml file: <westBoundary type = "Sponge" seaLevel = 0 widthNum = 1></westBoundary> <southBoundary type = "Sponge" seaLevel = 0 widthNum = 1></southBoundary> In the menu "Boundary" of the guy I set a Sinewave condition at North boundary side: Width Num =20 B. sea level=0 Wave amplitude=1 Wave period=5.8 Wave direction=-135 When the softwares starts, the direction of the wave under the boundary is different from the direction of input, as showns in the following image: I tried different directions of input in the guy, and the problem doesn't exist only for angles in the range of 20°, between -90° and -110° Someone can help me? Thanks Roberto

I downloaded the currently provided version of "Celeris (v1.3.1)" and tried to run the "celeris.exe" file and it asked me to load the .cml file. I loaded .cml file from one of the provided examples, such as "diagSolitary.cml", and then the program shut down after few seconds. It was just a white blank console before it shut down. I did try to reinstalling DirectX, but it certainly didn't work for me. Can anyone suggest me a solution? Thank you in advance!